Hello
Few days ago, after the observation, I PARK the scope. Today I try to unpark but is impossible.
I have a Synscan AZ GOTO e before work good with the Celestron GPS driver on my Raspberry, but now I have this messages:
Mount firmware does not support sync
Mount is parked.
Please unpark the mount before issuing any motion/sync commands.
Firmwre version 4.1 or higher is required to sync. Current version is 4.1
I want know if is possible to reset the system.
thank
Few days ago, after the observation, I PARK the scope. Today I try to unpark but is impossible.
I have a Synscan AZ GOTO e before work good with the Celestron GPS driver on my Raspberry, but now I have this messages:
Mount firmware does not support sync
Mount is parked.
Please unpark the mount before issuing any motion/sync commands.
Firmwre version 4.1 or higher is required to sync. Current version is 4.1
I want know if is possible to reset the system.
thank