Sesto Senso in Ekos - by: NH

Hello everyone,

I have bought the Sesto Senso from PrimaLuceLab and connect it to my focusser. Then I made a calibration with the Software from PrimaLuceLab. As a result the outermost position was 78889 (innermost 0). I left the Sesto Senso on Position 78889.

Then I edit my profile in Ekos with the Sesto Senso driver and started Ekos. It works and recongnized that the Sesto Senso was on Position 78889. Then I made a manule focus for testing at daylight. The focusposition was 61267. Then I shutdown Ekos.

Now the question: next time when I started Ekos it thinks that the Sesto Senso is on Position 78889. But in fact it is on position 61267 (where I left it when I shutdown Ekos). The problem is that Ekos thinks that this is the outhermost position. As a consequence I can only move the Sesto Senso between position 0 and 61267 (which Ekos thinks that it is 78889). I did not find out how to change that in Ekos. At the time I have only two Solutions: 1. do eyerytime before I start Ekos a calibration with the PrimaLuceLab software; 2. everytime before I shutdown Ekos I move the Sesto Senso to the outhmost position (e.g. 78889).

Is there an easier or better solution? I am sure it is but I am not able to find it. Thank you!