Hello
I am still fighting with my setup to get everything working right. Yesterday I've had quite bad feeling about my lodestar x2 camera after seeing first light.
Setup:
Lodestar x2 mono + canon 200/2.8 lens
Indiserver/linux + AstroImager/OS X (I have also tried Ekos - issue appeared again)
The problem is that from each bright star there is a strange horizontal bar with white and black lines - You can see that on the attached picture. Peter has informed me that it could be blooming effect. As I have understood what blooming is it was still quite strange because the effect is evident even on exposures as low as 0.5s.
![]()
I have contacted StarlightXpress and they have told me that it is just a matter of settings (they didn't mention blooming problem) and if I would use Maxim this can be fixed by turning in advanced setting on " swap even/odd rows " - below mentioned setting in maxim along with all recommended.
![]()
Now of course the question is how can I change this setting in indiserver?
I am still fighting with my setup to get everything working right. Yesterday I've had quite bad feeling about my lodestar x2 camera after seeing first light.
Setup:
Lodestar x2 mono + canon 200/2.8 lens
Indiserver/linux + AstroImager/OS X (I have also tried Ekos - issue appeared again)
The problem is that from each bright star there is a strange horizontal bar with white and black lines - You can see that on the attached picture. Peter has informed me that it could be blooming effect. As I have understood what blooming is it was still quite strange because the effect is evident even on exposures as low as 0.5s.
I have contacted StarlightXpress and they have told me that it is just a matter of settings (they didn't mention blooming problem) and if I would use Maxim this can be fixed by turning in advanced setting on " swap even/odd rows " - below mentioned setting in maxim along with all recommended.
Now of course the question is how can I change this setting in indiserver?