Ekos capture module prompts for DSLR settings every time - by: Catburglar

I can connect to my camera (Canon EOS1300D) with the indi_gphoto_ccd driver. The INDI control panel shows the correct parameters (W=5184, H=3456, Pixel_x and Pixel_y=4.3 micron). I've saved the settings and the driver reports that the config is loaded each time I start Indi.

But.....

Every time I switch to the capture module I'm prompted to enter the image parameters again. If I add them when prompted, then switch to focus or align and then go back to capture I get the prompt again.

Is there any way to stop this?