EKOS sequences instantly going to status complete - by: dokeeffe

I'm probably doing something wrong here so apologies in advance.
The first sequence run went good, the second one just instantly changed to 'complete' when I started the sequence.
Here is what I did

• In EKOS, the capture module, I selected all the settings, binning,exposure, temp etc set it for 8X captures, added this one line to the squence
• Started this sequence and everything went ok.
• Moved to another target, align, focus. Then went back to capture module to try again on the new target.
• When I click the start sequence button, no images are taken and all the rows in the table view change to 'complete'
• Deleted all rows from the sequence table view, re-add and try again. Same result.
• Tried the refresh button at the top of the sequence table view (re-evaluate) and tried again. Same result.
• Disconnect ekos, shutdown indi, shut down kstars, try from scratch (adding lines to the sequence) same result. No images taken,

I have attached a couple of screenshots and also saved the last .esq file. Can anyone help. Most likely I'm missing a step.


Thanks,
Derek

Sequence file saved: