Firstly I would like to thank everyone involved in this forum! This is the first time I have had to post as I have always found a solution by searching around the forum. I recently purchased a Pegasus FocusCube and was sold due to it having advertised INDI compatibility. Unfortunately I have been having a heck of a time getting it to connect in Ekos. I did get it to connect briefly (Logs are attached) but it timed out almost instantly and I have not been able to repeat or replicate it since. My setup is using a Raspberry Pi 3b+ at the scope and connecting to it remotely on the same network with my Macbook. I am running 2 ZWO cameras and EQMOD on a Orion Sirius HEQ5 mount. When I try to connect to the FocusCube it then also ends up timing out the EQmod mount. i am hoping that this is something simple as I am really excited about the focusing capabilities. I am fully updated and upgraded with the nightly builds. I did test the FocusCube with a Windows 10 computer with Pegasus app and it works with no issues.
↧