Hi!
After a few months away from astro stuff (moving to a new house), I now have unpacked and have enverything up and running again. And I ran into something that for me is new: on and off, the captured images shows all green in the FITS viewer, impossible to see anything. Setup: Canon 1000D on the scope, R-Pi at the scope running Indiserver, connected through an ethernet cable to the house where I run Ekos on a laptop.
THere seems not to be anything wrong with the subs as such - they open nicely in Pixinsight and looks good. So why green in FITS viewer? I do use a CLS clip on filter on the camera that supress the red, but since the subs are not debayered, they should be b/w, right?
And: on and off it looks as I expect, black & white images, very clear.
Any idea about what is happening here? What logs would be useful?
![]()
Magnus
After a few months away from astro stuff (moving to a new house), I now have unpacked and have enverything up and running again. And I ran into something that for me is new: on and off, the captured images shows all green in the FITS viewer, impossible to see anything. Setup: Canon 1000D on the scope, R-Pi at the scope running Indiserver, connected through an ethernet cable to the house where I run Ekos on a laptop.
THere seems not to be anything wrong with the subs as such - they open nicely in Pixinsight and looks good. So why green in FITS viewer? I do use a CLS clip on filter on the camera that supress the red, but since the subs are not debayered, they should be b/w, right?
And: on and off it looks as I expect, black & white images, very clear.
Any idea about what is happening here? What logs would be useful?
Magnus