Hi,
I tried to move my equipment to INDI. It worked so far. Bit I run into some problems using an Alnitak Flip Flat.
I have it in config. I could open and close the cap. I get the status.
But when I would like to switch the light on (which could be only done correctly when closed), the it does not light (it's OK, I counterchecked) and I get this error message:
2018-05-31T18:24:58: [ERROR] >S000 error: Write Error: Input/output error.
Anybody could help ?
Thanks in advance,
Michel
I tried to move my equipment to INDI. It worked so far. Bit I run into some problems using an Alnitak Flip Flat.
I have it in config. I could open and close the cap. I get the status.
But when I would like to switch the light on (which could be only done correctly when closed), the it does not light (it's OK, I counterchecked) and I get this error message:
2018-05-31T18:24:58: [ERROR] >S000 error: Write Error: Input/output error.
Anybody could help ?
Thanks in advance,
Michel